Dell A960 Ink Cartridge Refill Instructions

Carefully follow the refill instructions below to refill your black ink cartridges and also to refill your Dell A960 colour ink cartridges.

These instructions are based on using a Jettec refill kit with specifically formulated inks suitable for refilling Dell A960 ink cartridges although the principles are the same if you already have a refill kit.

Always Cover Your Working Area
With Folded Kitchen Paper In Case Of Ink Spillage

1. If refilling the black ink cartridge enlarge the hole on top of the cap with the drill provided.
2. If refilling the new style black ink cartridge peel off the top label
3. If you are refilling the colour ink cartridge, the cap must be removed first. Either hold the cap in a vice and snap off, or carefully lever off the cap with a penknife.
4. Assemble the syringe and needle, pierce the bottle seal and fill with the correct colour ink
5. Insert the needle down into the fill hole, if filling with colour ink ensure that you put the needle into the correct colour chamber.
6. Slowly inject the ink. During filling you may need to blot the printhead with a tissue.
7. When the colour ink cartridge is full ink appears at the fill hole, draw back the syringe plunger slightly until the ink disappears. Clean the syringe and needle thoroughly with water before filling with the next colour ink.
8. The black ink cartridge holds approximately 20ml of ink. Do not fill with more than this amount.
9. After refilling refit the lid. The best way to secure the lid is to stick tape from one side over the top and down the other side.
10. Note do not use a sealing plug with this cartridge.
11. Install the cartridge and run the cleaning cycle on the printer.
12. Clean the syringe and needle with water for future use.

For Best Results Refill Empty Cartridges Immediately