HP Digital Copier 610 Ink Cartridge Refill Instructions

Carefully follow the refill instructions below to refill your HP Digital Copier 610 ink cartridges.

These instructions are based on using a Jettec refill kit with specifically formulated inks suitable for refilling HP Digital Copier 610 ink cartridges although the principles are the same if you already have a refill kit

Always Cover Your Working Area
With Folded Kitchen Paper In Case Of Ink Spillage

1. The fill holes are located under the coloured top of the cartridge.
   
   
2. Pierce through the top of the label with an old ball point pen ( A ).
   
   
3. Assemble the syringe and needle , Pierce the bottle seal and draw up some ink.
   
   
4. Important the cartridge contains a felt material not sponge, so you will have to drip the ink into the appropriate holes very slowly. The felt material will naturally draw the ink into it.
   
   
5. Ensure the correct colour ink is injected into the appropriate chamber.



6. When the felt is saturated, wipe away any excess ink and place strong adhesive tape over the fill holes.
   
   
7. Install the cartridge and run a cleaning cycle. Please note the ink indicator may need to be turned off if so please follow these instructions.
   
   
8. Black press ( comma ) and ( full stop ) at the same time then release, on keypad press in order 7,8,9,3 when the prompt appears asking if you want to override the ink level gauge, press 1 for yes or 2 for no.
   
   
9. Colour press ( comma ) and ( full stop ) at the same time then release, on keypad press in order 4,5,6,3 when the prompt appears asking if you want to override the ink level gauge, press 1 for yes or 2 for no.
   
   
10. Clean the syringe and needle for future use.

For Best Results Refill Empty Cartridges Immediately

All brand names and trademarks are properties of their respective holders and referred to for descriptive purposes only.