Epson Stylus Photo 1280 Ink Cartridge Refill Instructions

Carefully follow the refill instructions below to refill your Epson Stylus Photo 1280 black ink cartridges and also to refill your Epson Stylus Photo 1280 colour ink cartridges.

These instructions are based on using a Jettec refill kit with specifically formulated inks suitable for refilling Epson Stylus Photo 1280 ink cartridges although the principles are the same if you already have a refill kit

Always Cover Your Working Area
With Folded Kitchen Paper In Case Of Ink Spillage

1. Use adhesive tape to cover the ink outlet port underneath the cartridge. Puncture the label with a ballpoint pen to reveal the filling holes.



2. Assemble the syringe and needle , Pierce the bottle seal and draw up some ink.



3. Insert the needle through the relevant fill hole and down into the foam. If filling a colour cartridge ensure that you inject the correct colour ink into the correct colour chamber.



4. Slowly inject the ink, Important the cartridge contains sponge and slight resistance may be felt.



5. When ink appears at the fill hole, draw back the syringe slightly until the ink disappears. The cartridge is now full. If you are filling a colour cartridge clean the syringe and needle thoroughly with water before filling with the next colour ink.



6. Do not remove tape from outlet ports, the tape is punctured when the cartridge is fitted to the machine and do not reseal the fill holes.



7. You will need a chip resetter to reset the chip. A chip resetter ensures that your printer registers your cartridge as full.



8. Install the cartridge and run the cleaning cycle on the printer. The best print quality will be achieved if the cartridge is left in the printer 24 hours before use.



9. Clean the syringe and needle for future use.

For Best Results Refill Empty Cartridges Immediately

All brand names and trademarks are properties of their respective holders and referred to for descriptive purposes only.