Canon BJ10SX Ink Cartridge Refill Instructions

Carefully follow the refill instructions below to refill your Canon BJ10SX black ink cartridges and also to refill your Canon BJ10SX colour ink cartridges.

These instructions are based on using a Jettec refill kit with specifically formulated inks suitable for refilling Canon BJ10SX ink cartridges although the principles are the same if you already have a refill kit

Always Cover Your Working Area
With Folded Kitchen Paper In Case Of Ink Spillage

1. Using the drill provided, make a hole at the small vent hole already present.
   
   
2. Assemble the syringe and needle , Pierce the bottle seal and draw up some ink.



3. If filling a colour cartridge ensure that you inject the correct colour ink into the correct colour chamber.



4. Insert the needle into the enlarged fill hole and into the foam and slowly inject the ink.
   
   
5. When ink appears at the fill hole, slightly draw back the syringe plunger until the ink just disappears. The cartridge is now full. If you are filling a colour cartridge clean the syringe and needle thoroughly with water before filling with the next colour ink.



6. Blot the printhead with absorbent material until the ink stops dripping



7. Install the cartridge and run the cleaning cycle on the printer.
   
   
8. Clean the syringe and needle for future use.

For Best Results Refill Empty Cartridges Immediately

All brand names and trademarks are properties of their respective holders and referred to for descriptive purposes only.